Revision [33457]
This is an old revision of LiveUSB made by coolpup on 2024-01-22 07:21:52.
Live Installation to External Device
Puppy Linux can run directly from an external device such as an USB flash memory drive, SD flash memory card, hard disk drive (HDD) or solid state disk drive (SSD).How to create a live installation to external device
- acquire the image file (with file extension .img or .iso) of the desired operating system, such as a recent Puppy Linux release (read Appendix 2)
- write (burn) the image file (with file extension .img or .iso) to an external device
How to write (burn) an image file to external device
- From within GNU/Linux
- ensure the target device is disconnected from the computer
- list all USB external devices connected to the computer, via the command-line interface:
lsblk
- connect the target device to the computer via an USB port
- IMPORTANT determine the correct device name (sdX) of the target device by invoking the lsblk command again, and compare both outputs:
lsblk
- write (burn) the image file (with file extension .img or .iso) to external device, via the command-line interface
- WARNING the dd command will overwrite all existing data on the target device X, where X represents the device letter for your target device - USE ENTIRELY AT YOUR OWN RISK:
time sudo dd bs=4M conv=notrunc,fdatasync oflag=direct status=progress if=<IMAGE FILE> of=/dev/sdX
- From within Microsoft Windows
- ensure an external device is connected to the computer, usually via a USB port
- use the free software Rufus (the latest version of Rufus requires Windows 8 or later; last supported version for Windows 7 is version 3.22)
How to run GNU/Linux from the external device
- ensure the external device is connected to the computer, usually via a USB port
- ensure that the B.I.O.S. is configured to follow the correct boot sequence (read Appendix 3)
- shutdown the computer and ensure that the computer is switched off
- switch on the computer
Categories
CategoryArchivingCategoryInstallation
